Show simple item record

dc.contributor.author Shamiranga, KLL
dc.contributor.author Fernando, PLN
dc.contributor.editor Mallikarachchi, C
dc.contributor.editor Hettiarachchi, P
dc.contributor.editor Herath, S
dc.contributor.editor Fernando, L
dc.date.accessioned 2023-10-10T04:02:43Z
dc.date.available 2023-10-10T04:02:43Z
dc.date.issued 2023-09-27
dc.identifier.citation ** en_US
dc.identifier.uri http://dl.lib.uom.lk/handle/123/21522
dc.description.abstract A blast load acting on a structure can be considered as an amalgamation of overpressure and impulse over an extremely short duration, which can cause catastrophic exterior and internal damage. Such blast loads can be generated due to either intentional or accidental actions. Due to growing threats, over the years, researchers have given special attention to studying the behaviour of structures when subjected to blast loads, and numerical modelling is a common approach used for such studies due to its practicality. However, existing modelling methods using advanced Finite Element Modelling (FEM) software can be complicated and computationally expensive and, in most cases, aims at studying the localised behaviour due to blast loads. On the other hand, Advanced FEM tools may require specialised expertise, limiting their accessibility for day-to-day structural design activities. This study aims to develop a general yet accurate model to simulate the complex behaviour of blast loads on a multi-storey building. To achieve this aim, two objectives are defined as identifying the applicable blast load parameters to represent the blast event accurately and simulating the behaviour of a building under positive overpressure due to blast loads. The approach approximates the blast load as a force at each node in the front face by multiplying the pressure by the tributary area and is implemented using finite element analysis. The approach is validated against data from open literature shown to be effective in predicting the response of structures to blast loads at a conservative level (49% difference for near-field explosions while 23% difference for far-field explosions). In this study, reinforced concrete buildings with three, six, and twelve storeys were modelled with blast loads of 1000 kg TNT at standoff distances of 5 m, 10 m, and 30 m from the building. Here, when the standoff distance is 5 m, it represents a near-field explosion, whereas when the standoff distance is 30 m, it represents a far-field explosion. The top-storey displacement due to the blast load was obtained as the main result, and a comparison was made to analyse the effect of blast load when there are shear walls and see the effect of slabs in resisting blast loads. The analysis was carried out using the commercially available finite element package, Midas Gen. The results demonstrate the potential of the proposed modelling technique to model the effects of the blast event with reasonable accuracy. However, it must be noted that the scope of this proposed approach is limited to structures that only need an initial blast load analysis and are not categorised as being vulnerable to blast loads. The results indicated that this method is more accurate for far-field explosions than for near-field explosions, where the expected behaviour of the structure is global and local, respectively. The top floor displacement is less than the no-shear wall scenario when there are shear walls. Also, the top floor displacement is less when there are slabs than in the no-slab scenario. In both situations, the rigidity of the structure due to laterally applied blast loads is high with shear walls and slabs. When the standoff distance is higher from the structure, it results in a uniform blast load on the front face, and at the same time, when the height of the buildings increases, they behave as cantilevers, and hence the top floor displacement is high. When the standoff distance is lesser from the structure, the blast load is localised, and the variation of top floor displacement is opposite to that in the far-field explosion. en_US
dc.language.iso en en_US
dc.publisher Department of Civil Engineering en_US
dc.subject Blast load en_US
dc.subject Finite element modelling en_US
dc.subject Midas gen en_US
dc.subject Far-field blast en_US
dc.title A general numerical modelling approach for blast loads on a building en_US
dc.type Conference-Abstract en_US
dc.identifier.faculty Engineering en_US
dc.identifier.department Department of Civil Engineering en_US
dc.identifier.year 2023 en_US
dc.identifier.conference Civil Engineering Research Symposium 2023 en_US
dc.identifier.place University of Moratuwa, Katubedda, Moratuwa. en_US
dc.identifier.pgnos pp. 35-36 en_US
dc.identifier.proceeding Proceedings of Civil Engineering Research Symposium 2023 en_US
dc.identifier.email lakshithaf@uom.lk en_US


Files in this item

This item appears in the following Collection(s)

  • CERS - 2023 [55]
    Civil Engineering Research Symposium 2023

Show simple item record